Auto Repair Manual Free Download and ReviewsFree download ebook pdf files automotive manual

download
1. Remove the powertrain control module (PCM) (2) from the battery box cover (1) and relocate to the side. 2. Release the locking tab (1) on the side of the battery box. 3. Release the alignment tabs (2) on the front of the battery box. 4. Remove the battery box lid (3). 5. Disconnect the positive and negative battery cables. Refer to [Battery Negative Cable Disconnection and Connection]. 6. Remove the battery hold down bolt (5), battery hold down (4), and washer (3). 7. Remove the battery (1). Installation Procedure 1. Position the battery (1) in the battery box (2). 2. Install the washer (3) and battery hold down (4). CAUTION: Refer to [Fastener Notice]. 3. Install the hold down bolt (5). Tightening torque Tighten the hold down bolt to 15 N.m (11 lb.ft) . 4. Install the positive and negative battery cables. Refer to [Battery Negative Cable Disconnection and Connection]. 5. Position the battery lid (3) so that the alignment tabs (2) are in position.

download
Compressor Assembly Removal 1. Run engine at idle with A/C ON for 10 minutes . 2. Disconnect negative (-) cable at battery. 3. Recover refrigerant from refrigeration system using recovery and recycling equipment. NOTE: The amount of compressor oil at removed must be measured and the same amount must be poured when installing the compressor. 4. Remove P/S pump referring to Step 4) to 7) of “Removal” in “P/S Pump Removal and Installation:”. NOTE: It is not necessary to drain P/S fluid. 5. Disconnect magnet clutch connector. 6. Disconnect suction hose (1) and discharge hose (2) from compressor.
NOTE: Cap open fitting immediately to keep moisture out of system.