Filed Under (Lexus) by admin on 27-09-2010
download
To improve power door window serviceability on SC 400/300, GS 300, and ES 300, a wire regulator subassembly is now available as separate supply parts. REPAIR PROCEDURES: ^ ^ ^ Verify motor operates properly. If the motor must be replaced, change the complete regulator assembly. If motor operation is correct, replace only the regulator subassembly. Use the following procedures when replacing the subassembly. 1992 Lexus SC 400 V8-4.0L (1UZ-FE) WINDOW REGULATOR DISASSEMBLY: 1. REMOVE COVER PLATE ^ Remove the two screws and cover plate; see figure 1. Note: The screws and cover plate are reusable. ^ Pry up the cover plate tab using a small flat-head screwdriver and remove the plate. Use care not to damage the motor housing; see figure 2. Note: The cover plate is not reusable. 2. REMOVE WINDOW REGULATOR DRUM AND WIRE GUIDE FROM MOTOR HOUSING USING NEEDLE NOSE PLIERS (SEE FIGURE 3). Caution: Do not use a flat-head screwdriver to remove the drum and wire guide. WINDOW REGULATOR INSTALLATION: 1. INSERT THE WINDOW REGULATOR DRUM INTO THE MOTOR HOUSING. 1992 Lexus SC 400 V8-4.0L (1UZ-FE) Note: ^ To prevent the window regulator drum and cable from coming off, do not tilt the drum, subject it to shocks or use force. If the cable comes off the drum, do not rewind the cable or reuse it. After the window regulator is installed, do not operate it manually (some window regulators do not utilize a stopper). ^ Multipurpose grease (P/N OO289-1WG00) should be applied to all moving parts, especially inside the motor housing and sides of the window regulator drum. Type “A” holding tool
Filed Under (Hyundai) by admin on 24-08-2010
download
NOTE: Both pulse generator-B inspection and TCM reprogramming procedures should be performed. PULSE GENERATOR-B INSPECTION PROCEDURE: 1. Open and secure the hood. 2. Remove the resonator. 3. Locate the pulse generator under the battery tray. Disconnect the pulse generator connector (blue) and remove the pulse generator male connector (black) from the bracket. 2001 Hyundai Accent GS Sedan L4-1.6L 4. Using an ohmmeter, check the resistance between terminal No. 3 and No. 4 in the disconnected pulse generator male connector (black color). Resistance value: 215-275W (at 20°C or 68°F) If the resistance is lower or higher than the specification, replace the pulse generator (P/N 45955-22700). If the resistance is within specification go to Step 5. 5. Clean both ends of the disconnected pulse generator connectors with aerosol electrical contact cleaner. 6. Apply contact grease (P/N 00305-F0000-39, NYOGEL 760G), into all four terminal openings of the blue female connector until each terminal opening is completely filled with grease. 7. Reconnect the pulse generator connectors and reattach the connector to the bracket. Reinstall all removed components in the reverse order of removal. TCM SPECIFICATIONS CAUTIONS BEFORE REPROGRAMMING:
Filed Under (KIA) by admin on 22-05-2010
download
Wheel Hub (Locking): All Technical Service Bulletins Drivetrain – 4WD Mode Inoperative SOURCE: Kia Technician Times TITLE: 4WD Control Vacuum Line APPLIES TO: Sportage 4WD SERVICE TIP: CONDITION 4 wheel drive mode inoperative (diagnosed either during or after replacing knuckles and hub seals) due to insufficient vacuum being applied to the hubs. CAUSE In some cases moisture has entered the vacuum system, and vacuum lines have become corroded, plugged, or have developed a leak.
CORRECTIVE ACTION
