s p o n s o r e d   l i n k s


2007 Toyota Camry REAR BUMPER Removal and Replacement

0

Filed Under (Toyota) by admin on 05-06-2010

Tags: , , ,

download
REMOVAL 1. REMOVE REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler) a. Put protective tape around the rear bumper assembly. b. Using a screwdriver, open the 2 rear bumper plates. HINT: Tape the screwdriver tip before use. c. Remove the 6 screws and 2 clips. d. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration. HINT: Use the same procedures for the RH side and LH side. e. Remove the rear bumper assembly. 2. REMOVE REAR FLOOR BOARD (w/ Rear Lower Spoiler) a. Remove the 4 screws, 2 clips, 3 nuts and rear floor board. 3. REMOVE REAR BUMPER ASSEMBLY (w/Rear Lower Spoiler)

Related posts:

  1. 2007–2008 Toyota Camry, Camry HV Body Cowl and Fender Creak
  2. 2001 Toyota Sienna CE Trunk / Liftgate Service and Repair DISASSEMBLY
  3. 2004 Toyota Sienna POWER SLIDING DOOR INOPERATIVE Repair Procedure
  4. 2004 Toyota Camry Rear Strut Assembly
  5. 2007 TOYOTA CAMRY/CAMRY HV INTERFACE KIT FOR IPOD Install

Comments are closed.

Related Items: , , , , , , , , , , , , , , , , , , , , , , ,