2007 TOYOTA FJ CRUISER TOWING HITCH Installation Procedure

0

Filed Under (Toyota) by admin on 15-01-2011

download
1. Prepare for Installation. (a) Verify kit contents (b) Wear safety glasses. (c) Raise vehicle. (d) Caution muffler might be hot NOTE: Apply masking tape to quarter panels above the bumper fascia. To prevent damage when removing the bumper fascia, apply masking tape on the underside of the bottom left- hand corner of the door and left hand upper corner of door. (Fig. 1-1) 2. Prepare Vehicle for Rear Bumper Fascia Removal. (a) Open rear door (Fig. 2-1). (b) Protect exhaust tip with a rag or protective tape during installation of hitch. (Fig. 2-1) NOTE: If the vehicle is equipped with proximity sensors, detach the sensor wire connector from inside the fascia, behind the rear wheels on both sides of the vehicle (Fig. 2-2). 3. Remove Rear Bumper Fascia. NOTE: Protect rear bumper to prevent damage from tools (i.e. air tools) when removing the fascia bolts. (a) Remove the 13 6 mm hex head bolts (A) from rear bumper fascia. (Fig. 3-1) (b) Remove one (1) push pin (B) from fascia (Fig. 3-1) (c) Unsnap the sides of the fascia from the vehicle. (Fig. 3-2) (d) With one person on each end, remove fascia from vehicle. Store in a safe place to avoid damage during installation. (Fig. 3-2) 4. Install Hitch. (a) Install one (1) M12 x 45 bolt into the 13 mm hole as shown (Bolt 1). (Fig. 4-1) (b) Install two (2) M12 x 45 bolts in the lower slots (Bolts 2 & 3). (Fig. 4-1) (c) Install three (3) M12 x 45 bolts in the 15mm holes (Bolts 4 to 6). (Fig. 4-1)

  2007 TOYOTA FJ CRUISER TOWING HITCH Installation Procedure Direct Download speed 4887 Kb/s

  2007 TOYOTA FJ CRUISER TOWING HITCH Installation Procedure Full Version speed 5767 Kb/s

Comments are closed.