download
DESCRIPTION & OPERATION Heating and ventilation system is a blend type system. A heater control valve is not used. Coolant flows unrestricted through heater core. Interior temperature is regulated by a blend door which controls amount of air flowing through heater core. Blend door is operated by a cable connected to temperature control knob. Three knobs are used to control blower speed, air temperature, and air distribution. Fresh air blower has 4 speeds. Blower motor resistor is located on blower motor housing. ADJUSTMENTS MAIN SHUTOFF FLAP CABLE Install heater control panel. Adjust blower control knob to stop at position “0″. Connect main shutoff flap cable (Black sleeve) to main shutoff flap lever. Push lever in direction of arrow until it stops. See Fig. 1. Hold lever in this position, and install cable retaining clip. TEMPERATURE FLAP CABLE Install heater control panel. Adjust temperature control knob to full cold. Connect temperature flap cable (Blue sleeve) to temperature flap lever. Push lever in direction of arrow until it stops. See Fig. 2. Hold lever in this position, and install cable retaining clip. Fig. 2: Adjusting Temperature Flap Cable Courtesy of Volkswagen United States, Inc. FOOTWELL/DEFROST FLAP CABLE Install heater control panel. Adjust airflow distribution knob to defrost position (against stop). Connect footwell/defrost flap cable (Black sleeve) to footwell/defrost flap lever. Push lever in direction of arrow until it stops. See Fig. 3. Hold lever in this position, and install cable retaining clip. Fig. 3: Adjusting Footwell/Defrost Flap Cable
Related posts:
- 1996 Volkswagen Golf BRAKE PRESSURE REGULATOR ADJUSTMENTS
- 1996 Volkswagen Golf COMPRESSOR CLUTCH CONTROL
- 1996 Volkswagen Golf ADJUSTMENTS AIR BAG SPIRAL SPRING REMOVAL & INSTALLATION
- 2001-04 STARTING & CHARGING SYSTEMS Starters – Golf, GTI & Jetta
- 1998 – 2005 Volkswagen B5 Platform 6-Speed Manual Transmission 01E adjusting Selector mechanism
